Skip to content
    Gavin Mai
    ← Apps

    Open Water

    A repairable, modular machine that makes drinking water from the air.

    Concept design. Nothing has been built yet, and there is nothing to buy.

    Open Water makes drinking water from the air. A fan pulls air across a cold coil, the water condenses on it, and it drips through a carbon filter into a 2-liter jug.

    It is designed to be repairable, modular and robust. The goal is drinking water, about one gallon per person per day, and you can add units for more.

    It sits on a counter. The cover twists off without tools. The fan lifts out the top, the electronics slide out the back on a tray, and the sealed cooling unit lifts out in one piece. All 24 screws are the same.

    Read the post about Open Water

    Design

    The unit cut through the middle, with arrows showing where the air goes.
    Cut through the middle. Air comes in at the top (grey). About 60% of it passes the cold coil (blue), where the water condenses. All of it leaves through the warm coil and the slots in the side (red). A small stream cools the compressor (orange).
    The unit taken apart, with its parts spread out from top to bottom.
    Taken apart. From the top: cap, air filter, fan, cover, the sealed cooling unit, then the base with the rear door, the electronics tray and the jug.

    Parts

    1. Air filterA washable mesh under the top cap. A second filter can be stacked on it.
    2. FanOne fan pulls the air in through the top.
    3. Cold coilA ring in the middle. The water condenses on it. It has a food-grade coating.
    4. Warm coilA ring around the outside. It gets rid of the heat, and the air leaves through the slots in the side.
    5. CompressorA small 24 V compressor in an insulated tube in the center. It and the fan are the only moving parts.
    6. Food-safe water pathA polypropylene trough, a stainless steel cup and spout, and a valve that stops the drip when the jug is out.
    7. Carbon filterA cartridge in the lid of the jug. The water drips through it.
    8. JugHolds 2 liters and slides out the front. The unit stops when the jug is full.
    9. UV-C lightShines into the jug from above the lid. It is off whenever the jug is out.
    10. Add-on outletA capped water outlet and a 24 V socket on the back, for add-ons such as a reverse osmosis filter. It makes its own water, so there is no inlet.

    Numbers

    Size
    230 mm across and 400 mm tall (about 9 by 16 inches)
    Weight
    About 5.5 kg (12 lb) empty
    Water
    6 liters (1.6 gallons) a day at 30 °C and 80% humidity. About 4 to 5 liters at 25 °C and 50%.
    Power
    About 60 to 135 watts, from an external 24 V power supply

    These are design targets from a simulation. Nothing has been measured yet, and the water has not been tested.

    Drawings

    Drawing sheet 1: General arrangement

    Sheet 1 of 15: General arrangement

    Click a sheet to open it full size. The drawings use the design’s working name, C5. They are also in one PDF.

    Preorder list

    There is nothing to order yet. Leave your email to hear when there is.